The use of a rapid prototyping method was utilised to produce a pre-operative solid model of the proximal tibia in a patient with a massive defect of the medial tibial plateau. The solid model was reconstructed from aligned sequential CT images of the knee. This was then used to determine the level of bone resection of the proximal tibia for the optimum placement of the tibial component of a total knee replacement. This technique gives the surgeon both the three-dimensional anatomical information needed to ascertain whether there is adequate bony support after cutting for the prosthesis, as well as a solid model on which to carry out the proposed surgery, before undertaking the procedure on the patient.
Minns RJ, Bibb R, Banks R, Sutton RA. The use of a reconstructed three-dimensional solid model from CT to aid the surgical management of a total knee arthroplasty: a case study. Medical Engineering & Physics 2003; 25: 523-526.
Dr. R. Julian Minns, NGH Unit, Newcastle upon Tyne. Tel: +44 (0)191-233-6161.
Regional Medical Physics Department, Freeman Hospital, Newcastle upon Tyne, NE7 7DN, UK.
Tel: +44 (0)191-233-6161 E-mail: webmaster@rmpd.org.uk Web: http://www.rmpd.org.uk
By using this site you agree to our Terms and Conditions of Use. Please read our legal page.
Regional Medical Physics Department, a Clinical Directorate of the Newcastle upon Tyne Hospitals NHS Foundation Trust.
Copyright ©1999-2008 All Rights Reserved. Revised 7 November, 2008.
